With an upcoming RV trip and school this year I wanted to make my daughter a bright and happy mask chain so the mask would not fall to the ground when she takes it off. Our obvious choice was to incorporate rainbows, so we did a DIY pastel rainbow mask chain!
This is a really simple and fun crafting project that I was able to do with my daughter in under 10 minutes.
Let me show you how I made this DIY pastel rainbow mask chain.
Disclaimer: Please note that some of the links below are affiliate links, and I will earn a commission if you purchase through those links (at no additional cost to you). Thank you for supporting me.
Supplies
Step 1
Cut your wire about 26-28″ long.
Step 2
Add any beads you have or the ones we used. We did a cute rainbow pattern.
Step 3
Add a crimp bead to the end of the wire. Make sure it does not slide into the inside of the other beads, that happened to me a few times!
Step 4
Slide a lobster clasp to the end of the wire.
Step 5
Take the end of the wire and pass it back through the crimp bead and back through about 3 beads. Adjust the beads and wire so that no wire is showing between the last bead and the crimp bead. This part was a little tricky but I figured it out eventually.
Step 6
Using your pliers, clamp down on the crimp bead until flat.
Step 7
Trim the excess wire and hide it inside that 3rd or 4th bead.
Repeat steps 3-7 for the other side.
Clasp to your favorite mask and you are ready to go!
If you love it, please pin this DIY Pastel Rainbow Mask Chain to your favorite board!
If you liked this project you might also like:
DIY Mother’s Day Thumbprint Necklaces (From the Kids)